It is odorless, inert and impervious to acid and alkaline emissions, sea air, industrial fumes, etc.
Does not contain solvents.
Easy to apply.
Does not run or drip in high temperatures.
Completely stable and very durable.
Protection against damp in walls, party walls, foundations, etc.
It is used as waterproof protection in coatings of mineral wool fiber, fiberglass, etc.
Especially suitable, diluted in water, as a primer for floors and facings under a subsequent application of asphalt membrane.
Instructions for use
Substrate: Should be firm and free of dust, greasy residues or non-stick agents, and in general any substance that impairs adhesion.
If there are any holes or voids, the surface must be smoothed beforehand.
Application method: The product is applied cold after it has been homogenized.
It is applied just as it comes in the container or diluted with up to 10-15% of water.
It should be applied when the temperature is above 10ºC and below 35ºC.
When several coats are being applied, these should be done crosswise to each other, leaving the first coat to dry completely for about 24-48 hours before applying the next coat (depending on the level of humidity and the ambient temperature).
It should not be left directly exposed to the sun.
Cleaning tools: Work tools should be washed with plenty of water before the product dries. If it has dried, the cleaning can be done with an industrial solvent.