Texturefix-120 View larger

Texturefix-120

New

Is a water-based acrylic and vinyl primer, to be used in construction as a bridge joint between new and old mortar shows good penetration and cohesion capacity due to its particle size and residual tack.
It also improve the conditions for adhesion to the vertical substrate supports, a step that should be taken before applying the covering.

Price per 5L.

More details

Quantity 1000

35,98 €

35,98 € per unid.

Add to wishlist

More info

Features and applications

  • TEXTUREFIX-120 is specially recommended to be used as primer before applying PAVILAND PLUS (horizontal supports), MORCEM TEXTURE (vertical supports) and any stamped, repair, polish, etc… mortars.
  • It increases the resistance to flexural cracks, as well as the cohesion and impermeability of the system
  • Apply a layer of TEXTUREFIX-120 as a primer on vertical supports. Avoid applying the product on exteriors when there's a risk of rain or frost.

Instructions for use

HORIZONTAL SUPPORTS

  • Support should be clean and free from grease, oil, oxide, paint remains and loose or badly adhered pieces.
  • Spread the product directly by means of a sprayer, making sure to leave a uniform film, without excessive product accumulation and avoiding overly thick layers.

VERTICAL SUPPORTS

  • The supports should be clean, dry, and well attached. Without diluting, apply a layer with a brush, roller, or spray gun.

Cautions and recommendations

  • Do not apply the product with ambient temperature lower than 5ºC or higher than 35ºC.
  • Do not apply either faced with risk of frost or rain, or with relative humidity over 85%.  Nor should it be applied under blazing sun.
  • The use of gloves is advisable during its manipulation.
  • TEXTUREFIX-120 is not toxic, dangerous or flammable under normal handling conditions. It is not necessary to use special safety measures, the stipulations provided in the Work Risks Prevention Law shall be applied at all times.