Pumaplast Exterior Fibrada List of Use 1KG

Features and applications

Applicable indoors and outdoors on brick, concrete, yeso, plastic paint...
Saddled and armed with dynamic frames and grids.
Practical way
Sobre clean, healthy, dry, free dust, fat and wax.
It is recommended to apply with lint-free wool or stainless steel spatula.
Clean the items after use.
Precautions and recommendations
The instructions reflected in the technical data sheet will be followed at all times.
Do not dilute.
Do not add additives or any other mixture of other paste products to the bowl, as this could alter the characteristics of the bowl.
The temperature conditions for the application of the masilla should not be lower than 5º C. or higher than 35º C.
If you are safe, you must not apply the product.
To obtain detailed safety information, consult the product safety data sheet.
Presentation
PUMAPLAST EXTRIOR FIBER LIST FOR USE if presented in a 5Kg bottle. 1Kg tartlet. y tube of 330gr. Deadline 12 months

Store the product in a dry and covered place, protected by the containers and exposed to direct sunlight. Keep the ground high to protect from moisture.

Technical data

Composition of organic polymers and inorganic cartridges
White colour
Type of Application Manual
Granulometry < 500 µ with fiber
UNE-EN 16566 regulation
Drying time 2 to 24 hours. by millimeter of thickness

Note

The instructions for use are made according to our knowledge and knowledge and do not imply compromise by the PUMA GROUP. They do not free the consumer from examining and verifying the products for their correct use. Claims must be accompanied by the original container to enable proper handling.

PUMA GROUP is not responsible, in any case, for the application of its products or construction solutions by the applying company or any other person intervening in the application and/or execution of the work in question, limiting the responsibility of PUMA GROUP exclusively to them possible damage attributable directly and exclusively to the products supplied, individually or integrated into systems, due to faults in the manufacturing of those.

In any case, the editor of the project of the work, the technical management or person responsible for the work, or subsidiarily the application company or the other relevant intervinients in the application and/or execution of the work in question, must ensure the suitability of the products by attending to the characteristics of the animals, as well as the conditions, support and possible pathologies of the work in question.

The values ​​of the products or construction solutions of the PUMA GROUP which in their case are determined in the UNE standard or whichever other than their application in each case refer exclusively to the conditions expressly stipulated in the regulatory provisions and which are referred, among others, to one specific characteristic of the support, humidity conditions and temperature, etc. since they are eligible for tests obtained in different conditions, everything must be taken into account with the expressly established in the reference legislation.